Ventis - VB00017 - Ventis HE275CF ZC Wood Fireplace - Unit

Ventis - VB00017 - Ventis HE275CF ZC Wood Fireplace - Unit

Ventis HE275CF Zero Clearance Wood Burning Fireplace is built for heating and EPA certified. It has a 2.5 cubic ft firebox that can handle up to a 20-Inch log and has a maximum burn time of up to 8 hours for one load of wood. It produces 80,000 BTUs to heat up to 2,200 square feet. The Ventis HE275CF fireplace requires 6" chimney venting and includes a 6" Rock-Vent Anchor Plate to start the chimney pipe off the top of the fireplace.

It uses a hot air gravity kit to maximize the heating output of the fireplace. The heat from the top of the fireplace rises up two pipes attached to the fireplace and is released through a grill on the wall above the fireplace. This hot air gravity kit is available in traditional and modern styles.

• Designed mainly for heating
  
• Large contemporary fireplace with single door
  
• EPA 2020 certified
  
• Non-catalytic combustion technology
  
• Installation authorized on the Island of Montreal
  
• Firestop made of high density insulation board
  
• Minimalist Ventis distinctive louver
  
• Molded refractory stones
  
• 6" Ventis stainless steel anchor plate included
  
• Fresh air intake adapter and andiron included

Required Option: 

• Choose one Hot Air Kit to complete this unit. Not Included, Sold Separately.
• Hot Air Gravity Kit Traditional (AC01375K) or Modern (AC01389K)

Appliance Performance

• Performances based on a fuel load prescribed by the standard at 7 lb/ft³ and with a moisture content between 19% and 25%.
• Optimum overall efficiency at a specific burn rate (LHV).
• This appliance is officially tested and certified by an independent agency.
• The maximum heat output (dry cordwood) is based on a loading density varying between 15 lb/ft³ and 20 lb/ft³. Other performances are based on a fuel load prescribed by the standard. The specified loading density varies between 7 lb/ft³ and 12 lb/ft³. The moisture content is between 19% and 25%.
• As measured per CSA B415.1-10 stack loss method.
• Higher Heating Value of the fuel.
• Lower Heating Value of the fuel.
• The optimum heat transfer efficiency is for the low burn rate (using HHV) and represents the appliance’s ability to convert the energy contained in the solid fuels into energy transferred to the room in the form of heat and does not take into account the chemical losses during combustion.
• Recommended heating area and maximum burn time may vary subject to location in home, chimney draft,heat loss factors, climate, fuel type and other variables. The recommended heated area for a given appliance is defined by the manufacturer as its capacity to maintain a minimum acceptable temperature in the designated area in case of a power failure.
• Carbon monoxyde.

General Features

• Download Product Catalogue
• Download Appliance Dimensions
• Download Installation and Operation Manual
• Fresh Air Intake Adapter Installation Instructions